Maxim Crane Works, LP v. Occupational Safety & Health Admin.
| Decision Date | 15 June 2022 |
| Docket Number | 21-3647 |
| Parties | MAXIM CRANE WORKS, LP, Petitioner, v. OCCUPATIONAL SAFETY & HEALTH ADMINISTRATION, U.S. DEPARTMENT OF LABOR, Respondent. |
| Court | U.S. Court of Appeals — Sixth Circuit |
NOT RECOMMENDED FOR PUBLICATION
ON PETITION FOR REVIEW OF AN ORDER OF THE OCCUPATIONAL SAFETY & HEALTH ADMINISTRATION.
Before: McKEAGUE, GRIFFIN, and READLER, Circuit Judges.
An employee of Petitioner Maxim Crane Works LP fell over nine feet while disassembling a crane for transport to a construction site. Respondent OSHA cited Maxim for violating its regulations requiring fall protection for employees. OSHA generally requires the use of fall protection at heights over four feet; but if employees are disassembling a crane as part of construction work, fall protection is only required for heights above fifteen feet. Maxim appealed the citation arguing that it was engaged in construction work at the time and was therefore in compliance. The Occupational Safety and Health Review Commission, relying on this court's opinion in Brock v. Cardinal Industries, Inc., 828 F.2d 373 (6th Cir. 1987), held that Maxim was not performing construction work and affirmed the citation. Maxim petitions for review of that decision. Because we agree with the Review Commission that Maxim's work lacked a sufficient nexus to a particular construction site, Maxim's petition for review is DENIED.
Maxim Crane Works, LP specializes in the rental and sale of crane and lifting equipment. Headquartered in Wilder, Kentucky, it operates locations across the country. Maxim's customer base includes multiple industries, but about 70-75% of its business serves construction industry customers. Relevant to this case is its yard in Ridley Park, Pennsylvania, where Maxim stores and maintains a fleet of primarily crawler cranes for rent to customers in the Philadelphia region.
In April 2017, a team of six employees was disassembling a Manitowoc 14000 crawler crane in preparation for transport. The Manitowoc 14000 consists of a superstructure-a substantial car body with treads-and a boom made up of multiple segments of latticed steel. The boom segments are eight feet wide, eight feet high, and forty feet long at their longest. For transport to a customer's site, Maxim must disassemble it into multiple tractor trailer loads-large enough to require state permits for oversized loads. Such disassembly usually takes two to three days. This particular Manitowoc had been assembled for operation at the Ridley Park yard after returning from the last customer. Maxim would use cranes around its yard for loading and unloading and inventory management. The Manitowoc was disassembled for transport to a construction site in New Jersey operated by Maxim's customer, Durr Mechanical. Once it reached the Durr Mechanical site, Maxim's employees were to assemble and operate the crane on that location.
During disassembly, one of Maxim's employees fell from the top of a section of boom while at a height of nine and a half feet. None of Maxim's team were using any method of fall protection while disassembling the crane. He was hospitalized, suffering a concussion, a fractured skull and scapula, and multiple lacerations.
Maxim reported the incident to the Occupational Safety and Health Administration via their hotline. Four days later, an OSHA Compliance Officer inspected Ridley Park. OSHA then issued a Two-Item Citation and Notification of Penalty to Maxim, for a total penalty of $25, 350. At issue in this petition, Item 1 was for a serious violation of 29 C.F.R. § 1910.28(b)(1)(i) for failing to ensure employees used fall protection while working more than four feet above the next highest surface.
Maxim contested the citation, and a hearing was held before the Chief Administrative Law Judge ("ALJ") in October 2018. In January 2020, the ALJ issued a decision affirming both citations and the proposed penalty. Maxim then petitioned the Occupational Safety and Health Review Commission for discretionary review. The Review Commission granted the petition to review only Item 1 of the citation, directing the parties to brief whether the cited general standard was preempted by the more lenient construction industry-specific standard, and specifically asked the parties "to discuss the Sixth Circuit's decision in Brock v. Cardinal Indus., Inc., 828 F.2d 373 (6th Cir. 1987)." Supp. App'x 186. In May 2021, the Review Commission issued its decision affirming the ALJ. See Maxim Crane Works, LP, No. 17-1894 (OSHRC May 20, 2021). Maxim then brought this petition for review pursuant to 29 U.S.C. § 660(a).
This court has jurisdiction to review Maxim's timely petition for review pursuant to 29 U.S.C. § 660(a). We review the Review Commission's findings of fact for substantial evidence. 29 U.S.C. § 660(a). The Review Commission's conclusions of law are set aside when they are "arbitrary, capricious, an abuse of discretion, or otherwise not in accordance with law."
5 U.S.C. § 706(2)(A); CMC Elec., Inc. v. Occupational Safety & Health Admin., U.S. Dep't of Lab., 221 F.3d 861, 865 (6th Cir. 2000). "We interpret the applicable regulations as we would a statute, and defer to the Secretary's interpretation only if a regulation's meaning remains unclear after 'exhaust[ing] all the traditional tools of construction.'" Lake Bldg. Prods., Inc. v. Sec'y of Lab., 958 F.3d 501, 504 (6th Cir. 2020) (alteration in original) (quoting Kisor v. Wilkie, ___ U.S. ___, 139 S.Ct. 2400, 2415 (2019)).
Maxim's petition turns on a single issue: whether the disassembly of its Manitowoc crane at its yard in Ridley Park, Pennsylvania constituted construction work for purposes of OSHA's regulations. OSHA argues that Maxim was properly cited under its general regulation requiring fall protections at heights above four feet, 29 C.F.R. § 1910.28(b)(1)(i). Maxim argues that the specific standard for the construction industry, 29 C.F.R. § 1926.1423(f), should be applied instead, which only requires fall protections at heights above fifteen feet.
Maxim does not dispute that the general standard applies to its disassembly. It instead argues that the construction standard also applies, and where two standards apply to given work, the industry-specific standard controls. See 29 C.F.R. § 1910.5(c)(1). Maxim's preferred standard falls within a part of OSHA's regulations pertaining to "Cranes and Derricks in Construction." See 75 Fed.Reg. 47, 906-01, 47, 906 (Aug. 9, 2010). These regulations, and the other construction-specific regulations within 29 C.F.R. § 1926, are incorporated as occupational safety and health standards applicable to "every employment and place of employment of every employee engaged in construction work." 29 C.F.R. § 1910.12(a). This provision incorporating the § 1926 construction regulations, § 1910.12, defines construction work as "work for construction, alteration, and/or repair, including painting and decorating." 29 C.F.R. § 1910.12(b).
We have confronted the question of whether an employee was engaged in construction work for purposes of OSHA's regulations before. In Brock v. Cardinal Industries, the Secretary of Labor sought review of a Review Commission decision interpreting § 1910.12. 828 F.2d 373, 375 (6th Cir. 1987), abrogated on other grounds by Martin v. Occupational Safety & Health Rev. Comm'n, 499 U.S. 144 (1991). Cardinal Industries built prefabricated homes and was cited by OSHA for violating a general standard. Id. at 374-75. It appealed the citation to the Review Commission, arguing that its employees were engaged in construction work and that therefore a construction industry standard applied, preempting the general standard. Id. at 375. The Review Commission looked to the nature of the work performed, concluded that it was construction work, and vacated the citation. Id. The Secretary sought review, and we reversed. Id. at 380.
Looking to the text of § 1910.12, we determined that the primary function of the employer's business and the nature of the work performed were not alone sufficient for work to be construction. See id. at 375-79. In its definition of construction work, § 1910.12 refers to "discussion of" the terms "construction, alteration, and/or repair" in 29 C.F.R. § 1926.13. 29 C.F.R. § 1910.12(b). Section 1926.13, in turn, notes that the "use of the same or identical terms" in the Davis-Bacon Act and the Miller Act have "considerable precedential value" in "ascertaining the coverage" of OSHA's construction regulations. 29 C.F.R. § 1926.13(a). We concluded that these cross references must be taken into account when interpreting the meaning of construction work in § 1910.12. Cardinal Indus., 828 F.2d at 378-79.
The regulations that interpret similar terms in the Davis-Bacon Act limit construction work to "work done on a particular building or work at the site thereof." 29 C.F.R. § 5.2(j)(1). A site of work is limited to "the physical place or places where the building or work called for in the contract will remain; and any other site where a significant portion of the building or work is constructed." 29 C.F.R. § 5.2(l)(1). These regulations, we acknowledge, may differ in some respects from the definition of construction work in § 1910.12. See CH2M Hill, Inc. v. Herman, 192 F.3d 711, 719 (7th Cir. 1999) (). Yet the Davis-Bacon Act regulations, by the terms of § 1926.13, have "considerable precedential value" in defining construction work in § 1910.12. By reading § 1910.12 in the context of these regulations and other interpretations of construction work, we concluded that "a finding of ...
To continue reading
Request your trial